Bilge Paint

It was about time to refresh the bilge.

It is now dry and i have applied a layer of epoxy resin both under the shaft box and on the bilge floor.

I have chose to use white epoxy to get more brightness. we'll see if in the future I'll go back to grey bilge paint as i guess the white one will get dirty very easily.

 









a

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Finally the hull is dry - It's Epoxy time

When I have started this project (september '17) I thought i was going to be sailing in March. well...that was not the case. it's b...

  • Sea cocks - Through hulls
    As usual a big concern was how good are the current through hulls? On the contest 29 these were melted into resin I guess as it gives stre...
  • New rigging, vhf antenna and windex
    So, few days before stepping the mast I had to place all the new rigging (stays and ropes) plus the new antenna (vhf) and the vindex. Also I...
  • Inboard engine: 1972 Arona 20hp
    Since its launch in 1972 Mizar had 2 engines mounted. the original from the conyplex shipyard was a Volvo MD2B 18hp which history I don'...