New rigging, vhf antenna and windex

So, few days before stepping the mast I had to place all the new rigging (stays and ropes) plus the new antenna (vhf) and the vindex. Also I have installed a new shackle for the boom topping lift oversized as it will be also used to lift the engine during the shaft alignment works.
Also the new stainless steel tabernacle has been placed and the wooden step prepared.


 






a

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Finally the hull is dry - It's Epoxy time

When I have started this project (september '17) I thought i was going to be sailing in March. well...that was not the case. it's b...

  • New rigging, vhf antenna and windex
    So, few days before stepping the mast I had to place all the new rigging (stays and ropes) plus the new antenna (vhf) and the vindex. Also I...
  • Hey! it's July!
    Sooooo... it's been a long time since I have last updated this blog and a lot has happened since. It's July! wasn't the boat g...
  • Bilge Paint
    It was about time to refresh the bilge. It is now dry and i have applied a layer of epoxy resin both under the shaft box and on the bilge ...