Hatches

The cabin hatches where leaking some water since long time so it was about to get them fixed.

It has been a really hard job since the stainless screws were stuck in the aluminium frame.
Some have to be drilled out some came off after many hours of wd-40 and attempts.

The old sealant was really hardened in some points and therefore retting the water in.
If I have to re-do a similar job in the future I would consider just applying epoxy resin from the outside of the hatch between glass, frame and fiberglass. much quicker and guaranteed result.














a

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Finally the hull is dry - It's Epoxy time

When I have started this project (september '17) I thought i was going to be sailing in March. well...that was not the case. it's b...

  • Sea cocks - Through hulls
    As usual a big concern was how good are the current through hulls? On the contest 29 these were melted into resin I guess as it gives stre...
  • Inboard engine: 1972 Arona 20hp
    Since its launch in 1972 Mizar had 2 engines mounted. the original from the conyplex shipyard was a Volvo MD2B 18hp which history I don'...
  • New rigging, vhf antenna and windex
    So, few days before stepping the mast I had to place all the new rigging (stays and ropes) plus the new antenna (vhf) and the vindex. Also I...